Calibration Wizard
The main purpose of the Wizard is to create new scheme calibrations. Those are used by neoStampa to print under the same conditions on the desired media. Following through the Wizard you can print different kinds of test charts, in order to control and set ink amounts, linearization curves and maximum ink limits, as well as printing an ICC target and creating an ICC printer profile. This Wizard also offers the option to check existing calibrations, without having to go through the whole process of measurements.
We recommend following the next notes to avoid calibration mistakes during the calibration process. Pay attention to the nozzle print quality in your digi...
Wed, 31 May, 2023 at 11:42 AM
updated for 10.1 Access the Calibration Wizard from the Printer Scheme Manager in neoStampa's upper bar on the main window. The Calibration wizard...
Wed, 18 Oct, 2023 at 6:11 PM
Once we have set up the different printing parameters in a new calibration, it is time to start printing step one of the calibration process. There are very...
Mon, 4 Dec, 2023 at 3:51 PM
To evaluate the test chart make sure that the print has dried and - if using textile material - fixated or steamed and washed. For some other media like pap...
Fri, 21 Apr, 2023 at 2:27 PM
This article helps you to manage the global ink cut when having specific conditions. Problem The common problems in Sublimation Calibrations are th...
Wed, 17 May, 2023 at 4:14 PM
Single Ink Cut evaluation When you finish reading Single Ink cut, the Densities and Ink cut dialog will show the result. This dialog shows the measurement ...
Wed, 10 May, 2023 at 10:44 PM
You will now get to the part to define the black generation of your printer calibration. This process allows determining which combination of inks provides ...
Thu, 4 May, 2023 at 12:18 PM
Once profiling targets are printed and measured according to the given specifications, in the measurement dialog you can view and compare the measurements. ...
Wed, 31 May, 2023 at 11:44 AM
When the measurement is completed and you will be asked to generate the profile with an internal application profiler. Gradient Few will be taken by default...
Mon, 18 Mar, 2024 at 11:50 AM
When we click Done after printer profiling, we reach the last window of the Calibration, a test workflow to verify the quality of the calibration using para...
Wed, 31 May, 2023 at 11:57 AM