Affects Version/s:

8.2


Problem

The common problems in Sublimation Calibrations are the ink yellow that causes problems with wrinkles and bleeding effect of the brown. Another problem is the combination of paper and inks. Here the goal is to get the best result using the combination and make a pre-cut of inks.


TIP: Ask paper and ink supplier for recommendations in usage of paper and/or ink.


This article helps you to manage the global ink cut when having specific conditions.


Solution

Before starting calibration we need to know what we want to find and where is the limit. Think on "Save" Calibration, which means to cut the inks without to think to lose the inks.



Step-by-step guide

  1. Print two copies of the chart.
  2. Print the chart which shows the problem and you can detect it, if necessary print the Extra chart to view the ink combinations.
  3. If required, scale the chart to the printer width for better print chart verifications, because the zones of ink combinations are bigger and problem can be detected faster.
  4. The global ink limit should be checked on paper and fabric. 
  5. Let the ink dry on paper, as longer as better.
  6. Transfer paper and verify the result on printed paper (copy 1), transferred paper and transferred fabric (copy 2).
  7. Each ink should be cut and treated individually to balances the ink limit in one level.

8. From Custom Ink Setup open Ink Curve and make a pre-cut of each ink in Y and X axis


9. Print the chart again and transfer paper and verify the result on printed paper (copy 1),
transferred paper


and transferred fabric (copy 2).


10. In Ink Limit put the value of global ink limit. In this example we use 70% of Ink Limit.