Calibration Wizard

The main purpose of the Wizard is to create new scheme calibrations. Those are used by neoStampa to print under the same conditions on the desired media. Following through the Wizard you can print different kinds of test charts, in order to control and set ink amounts, linearization curves and maximum ink limits, as well as printing an ICC target and creating an ICC printer profile. This Wizard also offers the option to check existing calibrations, without having to go through the whole process of measurements.

Tips before starting with Calibration
We recommend following the next notes to avoid calibration mistakes during the calibration process. Pay attention in the nozzle print quality in your digi...
Tue, 4 Oct, 2022 at 6:02 PM
How to make new printer calibration
updated for 10.1 Access the Calibration Wizard from the Printer Scheme Manager in neoStampa's upper bar on the main window. The Calibration wizar...
Tue, 4 Oct, 2022 at 6:01 PM
How to print and measure Ink Limit, Linearization and Profiling targets
Once we have set up the different printing parameters in a new calibration, now it is time to start printing step one of the calibration process. There are ...
Tue, 4 Oct, 2022 at 4:41 PM
How to evaluate the Ink Limit test chart
To evaluate the test chart make sure that the print has dried and - if using textile material - fixated or steamed and washed. For some other media like pap...
Tue, 4 Oct, 2022 at 6:04 PM
How to handle Ink Limit on Sublimation Calibration with low gram paper
This article helps you to manage the global ink cut when having specific conditions. Problem The common problems in Sublimation Calibrations are ...
Tue, 4 Oct, 2022 at 6:03 PM
How to evaluate measurements in Single Ink Cut and Linearization
Single Ink Cut evaluation When you finish reading Single Ink cut, the Densities and Ink cut dialog will show the result. This dialog shows the measurement ...
Tue, 4 Oct, 2022 at 3:28 PM
Which hueman v2 Black Generation is needed
You will now get to the part to define the black generation of your printer calibration. This process allows determining which combination of inks provides ...
Tue, 4 Oct, 2022 at 5:20 PM
Evaluation of profiling measurements
Once profiling targets are printed and measured according to given specifications, in the measurement dialog you can view and compare the measurements.  ...
Tue, 4 Oct, 2022 at 4:35 PM
Generation of Printer Profile in new calibration
When the measurement is completed and you will be asked to generate the profile with an internal application profiler. Gradient Few will be taken by default...
Tue, 4 Oct, 2022 at 4:47 PM
Complete calibration with one Calibration Test Print
We have reached the last window of the Calibration when hitting done after the printer profiling. A test workflow to verify the quality of the calibration u...
Tue, 4 Oct, 2022 at 5:55 PM