Measurement Settings with Spectrophotometers
Every supported spectrophotometer is managed with the own specific configuration and handling. Refer to the corresponding descriptions.
This option allows to make several measurements to export data to read the stability. Step-by-Step How to test? 1. Take one device and process calibra...
Mon, 9 May, 2022 at 5:40 PM
Measurement Settings, from Device select i1 Pro and connect the device to your computer. The dialog shows parameters to set for the measurement. INFO: Sup...
Mon, 9 May, 2022 at 5:36 PM
In Measurement Settings, from Device select eXact, connect the device to your computer and press the power button to turn on the device. Configure following...
Mon, 9 May, 2022 at 4:40 PM
Connect the device to your computer when is off and turn it on. Internal device calibration will start and you should wait until is completed. Start neoMatc...
Mon, 9 May, 2022 at 5:36 PM
Connect the device to your computer when is off and turn it on at the bottom of the device. Start neoMatch application and open Measurement Settings. Config...
Mon, 9 May, 2022 at 5:37 PM
Connect the device to your computer with the USB cable and turn it on at the bottom of the device until the blue light appear. Another option is to connect ...
Mon, 9 May, 2022 at 5:37 PM
Different as with other spectrophotometer, with CADDON option it can load the measurements in neoMatch. Start neoMatch application and open 'Measuremen...
Mon, 9 May, 2022 at 5:37 PM